TCP/IP Bluetooth to 2CH Wiegand Relay Controller

Introduction

This controller was developed to interface access control system. It has 2CH of Wiegand interface, 2CH input interface with two PIN to support push button (manual door open switch), 2 relay output and a 10M/100M Ethernet RJ45 port can be compatible for correspondence of TCP/IP communication and Bluetooth communication.It can realize two-way data conversion between 2 channel wiegand interface and network and Bluetooth. Default support wiegand26bit,34bit,66bit or other customized wiegand bit depend on each poject request.The controller working on DC9V to DC24V wide power supply, and also provide a TTL communication interface for testing and upgrade purpose. Consider its cheap price and good quality, it is really a good IOT Wiegand control device for access control.

Technical Parameter

Size: 110mm x 76mm x 20mm

Weight: about 50g (PCB board, without steel housing)

Network interface:10/100M

Bluetooth protocol:BLE 5.3

Networking protocol:DHCP TCP、UDP、HTTP

Ethernet user name: admin, Password: admin, Default IP: 192.168.0.7

Wiegand interface:support 2CH Wiegand input and output (WG26/34/66 bit)

Output: 2 channel of relay output, 1 channel of push button output

Communication interface: 10M/100M RJ45 Ethernet and Bluetooth

Baud rate: 9600BPS (default, can set by software)

Address ID: none (defaults ID none, can set by command, range: 1 to 255)

Indicator: LED indicator for power, TCP/IP communication and Wiegand communication

Reset button: press it about 3s for return to factory settings (after 4CH input LED bright red reset ok)

Door button:The 2 channel switch controls the 2 channel relay respectively

IO H/L input:2 Channel, Jumper settings for high and low level input;

Working power: DC9V to DC24V/1A, suggest DC12V

RFID Reade power: Set jumper for card reader power supply;

TTL interface: DC5V, TX, RX, GND, design for testing and upgrade firmware.

Operating Temperature: -40-85 C (-40-185 F)

Storage Temperature: -40～85 °C（-40～185 °F）

Relative humidity: 5%-95% (no condensation)

Appearance and connection